Mobatime DTS 4138.timeserver - Device Configuration with SNMP; DTS Subagent SNMP Notification; Startup [Dts4138 Startup]; Shutdown [Dts4138 Shutdown]

© MOBATIME 71 / 104 800870.05
9.2 Device configuration with SNMP
If one or several variables are set with Put in a configuration group, the variable
dts4138????ConfigCmd must be set at the end to 1 in the corresponding group. The
values of the entire configuration group are assumed from the DTS with this command
(1=Save).
As long as the accept command has not been set, the changed variables can be
restored to the old values by setting the dts4138????ConfigCmd variable to 2 (2=undo,
restore).
After sending the accept command, a dts4138ConfigChanged Notification is sent.
The definitions of the available variables can be taken from the MIB files.
Example:
Management-System DTS
Put dts4138FTPMode=1  Variable is set to 1 internally
Put dts4138NetServicesConfigCmd=1  Configuration group is assumed
 Sends dts4138ConfigChanged Notification
with the new time
dts4138NetConfigChangedTime
9.3 DTS subagent SNMP notification
Protocol: SNMPv2c Notification
For Notifications to be sent out, SNMP must be switched on. In addition, at least one
receiver system must be configured.
9.3.1 Startup [dts4138StartUp]
Sent out when the subagent for the DTS is started.
This Notification is always sent out, as soon as SNMP is activated and a destination
address is configured.
9.3.2 Shutdown [dts4138Shutdown]
Sent out when the subagent for the DTS is stopped.
This Notification is always sent out, as soon as SNMP is activated and a destination
address is configured.