9
Non-MobileVision Factory Pre Wired Installation (continued)
System Operation:
• Power up vehicle.
• Turn on monitor.
• Check for camera operation.
- Camera and monitor are paired.
- If camera is not paired, proceed to section
on camera pairing in this manual.
Figure A
Figure B
Connect the camera power lead to
the supplied adapter harness
Supplied adapter harness
Supplied 6’ power harness -
cut to approximately 6”
Black 12V +
12V +
12V -
Rec 12V -
Screw Driver
Screw Driver
Connect the adapter harness lead to
the vehicles pre wired power lead
Gasket
Gasket
Camera &
Bracket Assembly
Camera &
Bracket Assembly
Screws from Bracket
Screws from Bracket
Screws from Bracket
Screws from Bracket
Camera Adjustment Screws
(loosen only, do not remove)
Camera Adjustment Screws
(loosen only, do not remove)
To Next Page
Loading...