The configuration follows these five general steps:
a) Establish the first connection (Ethernet or ISDN).
b) Set the parameters for the desired connection type (Ethernet/ISDN) using the
Quick Installation.
c) Set the event control (events, actions and messages); see chapter 7,
Events,
Actions and Messages
, in the
Software Manual
.
d) Set the storage parameters (FTP, internal and external ring buffer storage).
e) Store the configuration in the camera's permanent storage (flash).
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
53/92
M12 Camera Manual Part 1
Always use Quick Instal-
lation for initial configu-
ration
Note
After first booting the new MOBOTIX camera or after resetting to facto-
ry defaults, accessing the Administration menu (Admin Menu button)
will automatically start the Quick Installation wizard. This is where you
configure the most important camera parameters in a step-by-step
manner. If you have completed the Quick Installation wizard at least
once, the standard Administration menu will open when you click on
the Admin Menu button.
Live image: http://preparkcam.mobotixserver.de
To Next Page
Loading...
