3.3.3 Ethernet: Power Supply Using PoE Products (Power over Ethernet)
• Connect the 10BaseT/NET connector of the camera to the Ethernet con-
nector of the switch/router. The network components need to support the
PoE standard IEEE 802.3af.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
58/92
M12 Camera Manual Part 1
PoE components without
fans increase overall reli-
ability of the entire sys-
tem
Note
If you are using IEEE 802.3af Power over Ethernet network compo-
nents for supplying power to MOBOTIX cameras, make sure that these
components do not have a fan. Since the power consumption of MO-
BOTIX cameras is very low compared to other products, this increases
the reliability of the entire system and expands the life cycle of these
components.
PoE IEEE 802.3af!
To Next Page
Loading...
