Mockmill Lino 100 - Getting Started and Cleaning

9
DE
EN
FR
ES
GETTING STARTED AND
CLEANING
ATTENTION:
Before starting your Mockmill
LINO 100 / 200 for the first
time, you‘ll need to remove the
transport lock. To find out how,
check page 11.
Before first use
Please mill a handful of grain
on scale 6 and then discard
the flour. This will remove
any mineral debris from the
manufacturing process on the
milling stones.
Getting started – Please
follow in order
1. Connect the plug to the
power socket
2. Place a bowl beneath
the chute
3. Switch on the mill
4. Select milling grade
5. Empty a handful of grains
into the hopper
6. Let the mill complete
the milling
7. Switch the unit off
8. Discard the resulting flour,
as this first milling removes
any mineral particles left
over from the manufacturing
process.
Don’t switch the Mockmill off
while it is milling.
ALWAYS switch the Mockmill on
prior to loading the hopper!
IMPORTANT: If you hear the
sound of stone contact before
reaching position 1 while
adjusting downwards, please
check the section “Choosing
milling settings” on Page 15.
Cleaning
The milling stones clean
themselves if you select a coarse
setting from time to time. If the
mill is not to be used for a while
(extended vacation, for example),
we recommend removing flour
residues by milling on a coarser
setting. Please see “How to clean
the Mockmill” on p. 7.