modway EEI -1328 - Page 5

Customer Service 908-368-1025︱
︱︱
︱www.modwayfurniture.com Page 5 of 8
EEI -1328 DESK
STEP 4:
STEP 5:
Place the Left Side Panel (B), Right Side Panel (C), Left Divide Panel (D) and Right Divide Panel (E) upside down
on a carpeted or padded surface.
Attach the 3 sets Drawer Guides (f) to the Left Side Panel (B), Right Side Panel (C), Left Divide Panel (D) and
Right Divide Panel (E) by using 12pcs Screw (g) as shown.
Use Phillips Head Screwdriver (not included) to tighten the Screws (g) clockwise until secure.
Insert 20pcs Cam Post (a) into the corresponding holes on the Top Panel (A), Left Divide Panel (D) , Right Divide Panel
(E), Left Bottom Panel (F) and Right Bottom Panel (H) as shown.
Use Phillips Head Screwdriver (not included) to tighten the Cams (a) clockwise until secure.
Insert 26pcs Dowel (h) into the corresponding holes on the Top Panel (A), Left Divide Panel (D) , Right Divide Panel (E),
Left Bottom Panel (F) and Right Bottom Panel (H) as shown.
ax20 hx26
Phillips Head Screwdriver
( not included)
Hardware & Tools required
A
Hardware & Tools required
fx3 gx12
Phillips Head Screwdriver
( not included)
B
C
D
E
C
C
f
f
g
g
g
g
g
g
g
g
g
g g
g
g
g
D
E
F
H
h
h
h
h
h
h
h
h
h
h
h
h
h
h
a
a
a
a
a
a
a
a
a
a
a
a
h
h
h
h
a
a
h
h
h
h
a
a
h
a
a
h
h
h
a
a