modway EEI-2273 User Manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 3
EEI-2273 SWING CHAIR
Hardware:
Component:
B
G
Spring x1
Thank you for purchasing the MODWAY SWING CHAIR！
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approx assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components and
hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that has been provided.
6.Please keep all fitting out of reach of children.
2
1
H
Spring Holder x1
K
Open Wrench x1
J
Allen Wrench x1
Bolt/Nut M10x55mm x1
C
Bolt/Nut M10x60mm x4
D
Bolt/Nut M10x20mm x3
E
Leveler x10
F
Screw Set M6x30mm x2
1
Left Base x1
4
Upper Stand x1
2
Right Base x1
3
Lower Stand x1
5
Basket Frame x1
6
Cushion x1
5
6
4
3

modway EEI-2273 Specifications

General

Brand	modway
Model	EEI-2273
Category	Indoor Furnishing
Language	English

Summary

Swing Chair Assembly Preparation

Helpful Advice for Assembly

Provides essential tips for safe and efficient assembly, including preparation and tool usage guidelines.

Hardware Identification

Lists all required hardware components with their respective quantities for assembly.

Component Identification

Identifies all furniture components with their corresponding labels and quantities.

Swing Chair Assembly Steps

Step 1: Base Assembly

Assemble the base components using specified bolts, nuts, and screw sets.

Step 2: Lower Stand Attachment

Attach the lower stand to the assembled base using specified bolts and nuts.

Step 3: Upper Stand Integration

Insert and secure the upper stand into the lower stand using a bolt and nut.

Step 4: Cushion Placement

Place the cushion onto the assembled basket frame.

Step 5: Basket Frame Hanging

Attach the spring holder and hang the basket frame to the upper stand using the spring.