modway EEI-2230 User Manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 3
EEI –2230/2231 CHAIR
Hardware:
Component:
D
Flat Washer M8 x 10
1
Chair Back x1
Thank you for purchasing the MODWAY CHAIR!
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of small children.
2
Seat Frame x1
3
Front Leg x2
A
C
Spring Washer M8 x 10
E
Allen Wrench x 1
2
3
1
3
Bolt M8x57mm x 6
B Bolt M8x90mm x 4
F
Dowel ø10x40mm x 1

modway EEI-2230 Specifications

General

Brand	modway
Model	EEI-2230
Category	Indoor Furnishing
Language	English

Summary

Assembly Guidance and Components

Helpful Advice Before Assembly

Provides advice on reading instructions, assembly by two adults, tool usage, and safety precautions for children.

Hardware and Components Overview

Lists all necessary hardware (bolts, washers, wrench, dowel) and chair components with quantities for assembly.

Chair Assembly Steps

Step 1: Attach Seat Frame to Chair Back

Connects the Seat Frame to the Chair Back using specific bolts, washers, and a dowel, advising not to fully tighten.

Step 2: Secure Seat Frame to Chair Back

Attaches the Seat Frame to the Chair Back using bolts, spring washers, and flat washers, advising not to fully tighten.

Step 3: Attach Front Legs

Installs the Front Legs into the Seat Frame using bolts, spring washers, and flat washers, advising not to fully tighten.

Step 4: Final Tightening and Setup

Turns the chair over, applies pressure for leveling, fully tightens all bolts, and reattaches Velcro.