modway EEI-272 User Manual

EEI-272 / EEI-273 / EEI-3417 / EEI-3418 OFFICE CHAIR
Customer Service 908-368-1025︱www.modway.com
Page 1 of 4
Thank you for purchasing the MODWAY OFFICE CHAIR.
Before you start, here are some helpful advice:
1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2. Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3. Please do not use any tools other than those provided or recommended in these instructions.
4. Please do not throw away any of the packaging or the instruction until you have checked all the components
and hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
and environmentally friendly way.
5. Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten
the components from time to time, so please save the tools that have been provided.
6. Please keep all pieces out of reach of children.
Hardware:
Components:
Bolt M8x45mm x4
Crash Pad x4
1. Base x1 2. Cylinder Column x1 3. Castor x5
A.
B.
Allen Wrench x1
D.
4. Back with Control Mechanism x1 5. Arm x2
Cap Cover x4
C.
EEI-272/ EEI-3417
EEI-273/EEI-3418

modway EEI-272 Specifications

General

Brand	modway
Model	EEI-272
Category	Indoor Furnishing
Language	English

Summary

Helpful Advice and Product Identification

Helpful Advice

Provides essential tips for chair assembly, including reading instructions, assembly by two adults, and tool usage.

Hardware Identification

Lists all necessary hardware components for chair assembly, including bolts, pads, covers, and an Allen wrench.

Chair Components

Identifies the main parts of the office chair, such as the base, cylinder column, castors, back, and arms.

Step 1: Base Assembly

Attach Castors to Base

Instructions for inserting five castors into the chair base on a carpeted or padded surface.

Step 2: Cylinder Column Installation

Install Cylinder Column

Procedure for inserting the cylinder column into the assembled chair base.

Step 3: Arm Attachment

Attach Arms to Back

Guide for attaching chair arms to the back with control mechanism using bolts, crash pads, and cap covers.

Step 4: Back and Cylinder Connection

Connect Back to Cylinder

Instruction to insert the back with control mechanism into the cylinder column.

Step 5: Assembly Complete

Final Check and Usage

Confirms assembly completion and provides an attention note for adjusting chair height.