modway EEI-1109 User Manual

EEI-1109 & 3869 OFFICE CHAIR
Customer Service 609-256-9000︱www.modway.com
Page
1
of 4
Thank you for purchasing the MODWAY OFFICE CHAIR!
Before you start, here are some helpful advice:
1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2. Owing to the size and weight of the office chair, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3. Please do not use any tools other than those provided or recommended in these instructions.
4. Please do not throw away any of the packaging or the instruction until you have checked all the components
and hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
and environmentally friendly way.
5. Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten
the components from time to time, so please save the tools that have been provided.
6. Please keep all pieces out of reach of children.
Hardware:
Components:
Bolt M6x25mm x2
1. Base x1 2. Gas Lift x1 3. Castor x5 4. Fixing Plate x1
A.
Allen Wrench x1
5. Seater Frame x1 6. Backrest x1 7. Seater x1
C.
Flat Washer x4
D.
Bolt M6x20mm x2
B.
Nut M12 x2
E.
Spring Washer M12 x2
F.
Nut Driver x1
G.

modway EEI-1109 Specifications

General

Brand	modway
Model	EEI-1109
Category	Indoor Furnishing
Language	English

Summary

Office Chair Assembly Preparation

Helpful Advice Before Assembly

Provides essential advice and recommendations before starting chair assembly, including safety and preparation tips.

Included Hardware

Lists all hardware components (bolts, nuts, washers, tools) provided for chair assembly with quantities.

Chair Components Identification

Lists and identifies all main parts of the office chair, numbered for easy reference during assembly.

Step 1: Attach Backrest to Seater Frame

Step 2: Mount Seater to Seater Frame

Connects the Seater (7) onto the assembled Seater Frame (5), ensuring proper alignment of holes.

Step 3: Attach Fixing Plate

Step 4: Assemble Base and Gas Lift

Attaches the five Castors (3) to the Base (1) and inserts the Gas Lift (2) into the center.

Step 5: Connect Seat Assembly to Base

Height Adjustment Attention

Provides an important safety note on how to adjust the chair height correctly, advising foot placement.