User Manual v1.5
Page 51 of 64
MOFI RECOVERY (For MOFI4500 V3 only, note for
the V1/V2 version, it has a bit different process)
How to recover router from wrong file update or other problem
This MOFI utility will restore your MOFI MOFI4500-4GXeLTE V1/V2 router back to
working mode.
It will only work on any operating system like Windows, MAC, Linux
Here is a video on how do this:
https://www.youtube.com/watch?v=_1dJPC_X5Io&t=2s
On the MOFI4500-4GXeLTE V3 model, it has 2 type of recovery.
The first step will not require recovery file but this recovery does
not work if the directory gets deleted
To try, simple follow the basic steps
Step 1: Take the power off the router
Step 2. Hold the reset button down at the back of the router
Step 3: Power on the router and keep holding the reset button.
Note about 5-6 seconds, you will see the 2rd led (internet LED) start
to flash. Keep holding down and a few seconds later, you will see
the internet LED start to flash faster.
When you see this, release the reset button at the back of the
router and wait about 2-3 mins and see if the router will recovery
and if the Power LED goes solid.
If it does, then you can connect to the wifi and log into the router
http://192.168.10.1
then you can download the latest firmware of the V3 firmware on
our side and do the update.
If this step does not work, then you will need to do the recovery
where you will need to connect the router with an Ethernet Port.
You will need to download the recovery firmware.
At the same time, you should download the latest firmware for the
MOFI4500 V3 download.
Here is a link to the MOFI4500 V3 Recovery file:
http://mofinetwork.com/firmware/mofi4500v3/MOFI4500V3_RECOVERY.bin
Step 1: Set router is recovery mode
Connect the router to your pc with an Ethernet cable to port 1 at the back of the
router.
Unplug the router and press and hold the reset button on the back of the router.
To Next Page
Loading...
