User Manual v1.0
Page 13 of 59
Installing your Router
The MOFI4500-4GXELTE-SIM4 can be used in many ways including as a 3G/4G/LTE/LTE2 router or just a regular
Cable/DSL/Satellite high speed router.
Using a SIM card from your provider direct from provider
1. Insert your SIM card in the SIM card slot on the side of the router and connect all 4 antennas to router.
2. Connect the power cable to the router’s power jack and plug it in to the wall socket.
3. Connect your PC to any available Ethernet port using an Ethernet cable or connect via wireless.
(do not use the WAN)
4. At this point, your connection should be connected. If not, you might need to go to the 3G/4G/LTE build in modem
section in basic mode and make sure you provider and correct APN is selected
Using a DSL or Cable Modem or Satellite Modem
If you choose to use a DSL, Cable or Satellite modem you are required to have the following:
DSL or cable modem or Satellite modem
Active Internet Account
1. Connect your DSL, Cable or Satellite modem to the router’s WAN port using an Ethernet cable.
2. Connect the power cable to the router’s power jack and plug it in to the wall socket.
3. Connect your PC to any of available Ethernet port using an Ethernet cable or connect via wireless.
If you are using a Satellite system like Xplornet, you should log into the MOFI router and run the wizard. You will see
the option in the wizard to select Xplornet. This will set up the router with optimized satellite settings automatically.
Note: Ensure that the router’s IP address does not conflict with the DSL/Cable/Satellite modem. Please refer to your
modem’s User Manual on how to change the LAN IP address. The default IP on the MOFI4500-4GXELTE-SIM4 is
192.168.10.1
To Next Page
Loading...
Need help?
General
