Mojotone TMB - Page 12

www.mojotone.com
11
10 nF 10 nF 10 nF
10 nF
4.7 nF
22 nF 22 nF 22 nF
100K
100K
100K
100K
820 Ω
820 Ω
10K
47K
47K
470K
470K
470K
470K
470K
470K
470K
5.1K
16uF
22 nF
22 nF 680 nF
47 pF
500 pF
500 pF
25uF
+
100 Ω
100Ω
2.7 K
5.1K
820 Ω
100K
100K
2.7 K
130 Ω
25uF
+
10 nF 10 nF 10 nF
10 nF
4.7 nF
22 nF 22 nF 22 nF
100K
100K
100K
100K
820 Ω
820 Ω
10K
47K
47K
470K
470K
470K
470K
470K
470K
470K
5.1K
16uF
22 nF
22 nF 680 nF
47 pF
500 pF
500 pF
25uF
+
100Ω
100Ω
2.7 K
5.1K
820 Ω
100K
100K
2.7 K
130 Ω
25uF
+
CROSS-SECTION OF TURRET BOARD CAPACITOR AND RESISTOR TWISTED TOGETHER
COMPLETED TURRET BOARD
PRO Tip: When a capacitor and resistor are both
running between the same turrets, you can twist
their leads, one around the other, and solder to
form a solid mechanical connection.
Once all components, jumpers, and leads are in
place, start at one end of the board and begin sol-
dering every turret.
Make Sure you don’t have any bad or “cold” solder
joints by lightly pulling each wire after solder has set.
10 nF 10 nF 10 nF
10 nF
4.7 nF
22 nF 22 nF 22 nF
100K
100K
100K
100K
820Ω
820Ω
10K
47K
47K
470K
470K
470K
470K
470K
470K
470K
5.1K
16uF
22 nF
22 nF 680 nF
47 pF
500 pF
500 pF
25uF
+
100 Ω
100Ω
2.7 K
5.1K
820Ω
100K
100K
2.7 K
130 Ω
25uF
+
JUMPER WIRES AND LEADS TO CHASSIS COMPONENTS