MX123 Connection System User Manual - AS-34566-001 72
STEP 3: Carefully remove any remaining debris from the slide area with a small
brush. Do not attempt to un-mate any connectors until Step 4.
STEP 4: You will need to start to cycle the lever arm to determine if you have
excessive resistance. If lever arm binds, or resistance is felt. Repeat steps
1, 2, and 3 until the connector is visibly clean and offers little resistance to
un-mating.
Step 1 Step 2
Section 11 (Appendix B): Cleaning Instructions
To Next Page
Loading...
