Rev E 24/09/2013 BM06101 Molift MOVER 300 English Page 17 of 20
Service
Molift Mover 300 has a LED on the battery holder
indicating if the lifter needs service. The LED gives
a green light when the lifter is ready for use.
The electronics logs how much the lifter is being
used, and the load it is used with. After a given
time of usage there will be given a signal that the
lifter needs service to the service LED. The LED will
rst give a yellow light, then red. Take contact with
your local service representative and order serv-
ice. If there is a sound together with the light, it
means the lifter needs service immediately.
Service lamp Status
No light Power save
Green Ready for use
Yellow Order service, lifter still
works
Red Perform service
Red + sound Perform service imme-
diately
Service consists of replacing the lifting motor and
check/replacement of worn or damaged parts.
Service and repair shall be performed only by an
authorised service representative according to
procedures in the technical manual.
The service partner uses the Molift Service Tool to
read the data from the lifter, and for logging serv-
ice and resetting the service LED. The owner is re-
sponsible to ensure proper logging and written
verication performed by authorised service part-
ner.
A list of spare parts is avalable on request
Battery lamp
Service lamp
Electrical emer-
gency lowering
To Next Page
Loading...
