Page 6 of 20 BM06101 Molift MOVER 300 English Rev E 24/09/2013
Disassembly
• Remove the suspension.
• Run the lifting arm all the way down.
• Remove the battery to avoid it from falling out
during transport.
• Release the lock handle on the chassis end re-
move the complete column with lifting arm.
• Place the hand control on the drive handle.
Storage
For long time storage it is recommended that the
battery is removed and the emergency stop but-
ton is activated. The lifter can be stored and trans-
ported under the following conditions:
Pressure: 70 - 106 kPa
Humidity: 15 - 93 %
Temperature: -25 - 70 °C
The lifter is designed for use at standard room
temperatures (+5 to +40°C). Following storage or
transport at other temperatures leave the lifter in
a room with a suitable temperature until it reaches
a safe operating temperature.
To Next Page
Loading...
