To Next PageTo Next Page
Need help?Do you have a question about the Monacor SAM-2 and is the answer not in the manual?
Details controls for SUB LEVEL, CROSSOVER, PHASE, BOOST, and the LED indicator status.
Explains the POWER switch and the GROUND LIFT switch for noise reduction.
Describes mains jack, HIGH LEVEL INPUT, LINE IN, and SAT OUT connections.
Details the fuse support and replacement guidelines.
States EU compliance and warns about dangerous mains voltage during installation.
Explains the SAM-2's use as an active subwoofer amplifier.
Critical safety warning about connecting the module to mains voltage during installation.
Details required cabinet cutout dimensions and speaker connection requirements.
Instructions on how to securely mount the module into the cabinet using screws.
Important safety and polarity guidelines for using the HIGH LEVEL INPUT.
Details how to connect the SAT OUT to a stereo power amplifier.
Step-by-step instructions for connecting the mains cable.
Guides on using the groundlift switch to eliminate humming.
How to set the upper crossover frequency for the subwoofer.
Adjusting volume ratio and subwoofer phase for optimal sound.
Using controls to boost bass frequencies and set the frequency.
Adjusting the lower crossover frequency for satellite speakers.
Module standby on short circuit or DC voltage at the output.
Module standby due to overheating, requiring improved ventilation.
Lists output power ratings and frequency response for subwoofer and satellite outputs.
Details input impedance, power supply voltage, and power consumption figures.
Provides physical dimensions, required cutout, weight, and operating temperature.
Details controls for SUB LEVEL, CROSSOVER, PHASE, BOOST, and the LED indicator status.
Explains the POWER switch and the GROUND LIFT switch for noise reduction.
Describes mains jack, HIGH LEVEL INPUT, LINE IN, and SAT OUT connections.
Details the fuse support and replacement guidelines.
States EU compliance and warns about dangerous mains voltage during installation.
Explains the SAM-2's use as an active subwoofer amplifier.
Critical safety warning about connecting the module to mains voltage during installation.
Details required cabinet cutout dimensions and speaker connection requirements.
Instructions on how to securely mount the module into the cabinet using screws.
Important safety and polarity guidelines for using the HIGH LEVEL INPUT.
Details how to connect the SAT OUT to a stereo power amplifier.
Step-by-step instructions for connecting the mains cable.
Guides on using the groundlift switch to eliminate humming.
How to set the upper crossover frequency for the subwoofer.
Adjusting volume ratio and subwoofer phase for optimal sound.
Using controls to boost bass frequencies and set the frequency.
Adjusting the lower crossover frequency for satellite speakers.
Module standby on short circuit or DC voltage at the output.
Module standby due to overheating, requiring improved ventilation.
Lists output power ratings and frequency response for subwoofer and satellite outputs.
Details input impedance, power supply voltage, and power consumption figures.
Provides physical dimensions, required cutout, weight, and operating temperature.
General