Moneris Go Plus - Terminal Hardware and Interface

Moneris® Go Plus: Setting up Your Terminal 3
Hardware setup
Install the receipt paper
1. Lift the printer latch up to release the printer cover, then pull the
cover back to expose the paper compartment.
2. Insert the receipt paper roll into the paper compartment with the
loose end unrolling away from the terminal.
3. Unroll enough paper to extend at least one inch (2.5 cm) past the
top of the printer cover.
Note: If the paper is installed backward, your printouts will be
blank.
4. Close the printer cover and press down to snap it back into place
so that the extended paper is held securely.
Hardware setup is complete.
5. Continue to Charge the battery.