Moneris® Go Plus: Setting up Your Terminal 5
Use the optional charging base
Use the optional charging base if you have it, otherwise continue to Power on the terminal.
1. Unfold the charging cable and insert the USB connector into the USB
port in the back of the base.
Note: See manual in the box.
2. Make sure the AC adaptor is connected to the other end of the
charging cable. Plug the AC adaptor into a working electrical outlet.
Note: Use a power bar to avoid electrical surges.
3. Dock the terminal on the base. Ensure the terminal fits securely over
the two prongs on the base.
4. The terminal displays the charging screen.
a. Wait for the battery charging icon to display. This indicates that
the terminal is receiving power and the battery is charging.
b. Continue charging the terminal during the rest of the setup
procedures.
5. Continue to Power on the terminal
.
To Next Page
Loading...
