MR6550
User Manual
9
ENGLISH
Electrical cautions
Make sure to use only the specified voltage and current.
Power supplies outside the specification ranges may cause serious damage to the product.
If Robot cleaner is stored for long time without being used, the main battery can become
discharged.
When storing the device for a long period of time, make sure to turn off Power switch on the rear.
Do not use a damaged power cord or plug.
There is chance of shock and/or serious injury.
If the power cord of the charger is damaged, contact the service center immediately.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
Make sure that the power cord is not pulled or pressed down by doors.
The power cord can be pulled out or damaged.
When connecting / disconnecting the plug into / from the receptacle, make sure to do so by
holding the plug part, rather than pulling on the cord.
Do not touch the power cord with wet hands.
You can get shocked.
If water gets on the robot cleaner, unplug the power plug and dry completely before using
again.
An electric shock or a fire may occur. If water enters the product, contact the service center.
Use the enclosed charger only.
The product may be damaged due to overvoltage, or a fire or electric shock may occur.
Do not install the charger in a place which is damp or dusty, where water splashes or where
steam is emitted.
The product may malfunction, or shock or damage to the product may occur.
Do not contact any metal objects such as clips and pins with the charger terminal.
It can cause electric shock and/or fire.
For indicator power, use rated batteries and adapters only.
If not, the product can be damaged, set on fire, or it may malfunction.
In case of insufficient indicator battery, replace with a new one.
Without batteries, indicator functions may not work normally.
To Next Page
Loading...
