Need help?Do you have a question about the Monoprice MP Mini Delta and is the answer not in the manual?
Step-by-step guide to install the Cura slicing software on Windows.
Statement regarding compliance with FCC Rules and operational conditions.
Statement regarding compliance with Canadian ICES-003 standards.
General| Nozzle Diameter | 0.4 mm |
|---|---|
| Filament Diameter | 1.75 mm |
| Connectivity | USB, SD Card |
| Bed Type | Heated |
| Print Technology | FDM |
| Build Volume | 110mm x 110mm x 120mm |
| Supported Filaments | PLA |
| Print Speed | up to 100 mm/s |
To Next Page