34
E
When the LAP function is set to Off in the menu, the current
”lap” is not stored.
If the LAP function is active and the display is suddenly
switched off (Key-Off), the LAP function is switched off
automatically (even if the timer was ON, the lap in progress
is not saved).
If the lap timer is not stopped, it will roll over upon reaching
9 minutes, 59 seconds and 99 hundredths; the lap timer
starts counting from 0 (zero) and will keep running until the
function is disabled.
If the LAP function is enabled without resetting the
”memory” and there are less than 30 laps stored in the
memory (for instance: 18 laps), the display will store any
remaining laps until the memory is full (in this case, it will
store an additional 12 laps).
This function only displays lap times; however, lap times are
saved for subsequent display in the Lap Memory function.
To Next Page
Loading...