48
E
Entering the code:
when you access this function, the first digit on the left will
flash.
Switch (1, fig. 10):
each time you press the switch in position B “▼”, the
number increases cyclically in steps of one digit every
second;
if you press the switch in position A “▲”, you can set the
second digit, which will start flashing. Each time you press
the switch in position B “▼”, the number increases cyclically
in steps of one digit every second;
if you press the switch in position A “▲”, you can set the
third digit, which will start flashing. Each time you press the
switch in position B “▼”, the number increases cyclically in
steps of one digit every second;
if you press the switch in position A “▲”, you can set the
fourth digit, which will start flashing. Each time you press the
switch in position B “▼”, the number increases cyclically in
steps of one digit every second;
if you press the switch in position A “▲”, you can set the
fifth digit, which will start flashing. Each time you press the
switch in position B “▼”, the number increases cyclically in
steps of one digit every second;
press in position A “▲” to confirm the code.
If the code has been entered correctly, the message CODE
and the code itself will flash simultaneously for 4 seconds.
The ”Vehicle/engine diagnosis EOBD” light (8, fig. 4) will
turn off; The instrument panel then automatically exits the
menu, thus allowing “temporary” starting of the motorcycle.
If the error is still present, at the next Key-On the instrument
panel error and the inhibited status will persist.
If the code is not entered correctly, the instrument panel
returns automatically to the “COD” menu, displaying code
“00000”.
To Next Page
Loading...