7
5. Setting up the device
Menu level Parameterization level
Rescaling the measuring input values,
With the aid of this function, one can rescale the input value of e.g. 19,5 mA
(works setting) without applying a measuring signal. If sensor calibration has been
selected, these parameters are not available.
Rescaling the measuring input values,
With the aid of this function, one can rescale the input value of e.g. 3,5 mA (works
setting) without applying a measuring signal. If sensor calibration has been
selected, these parameters are not available.
Setting the tare/offset value,
Default:
The given value is added to the linerarized value. In this way, the characteristic
line can be shifted by the selected amount.
Zero point slowdown,
Default:
With zero point slowdown, a value range around zero can be preselected at which
the display shows zero. If, for example, a 10 is set, the display would show a zero
in the range from -10 to +10 and continue below it with -11 and above it with +11.
5.4. Extended parameterization
By pressing the [▲] & [▼] keys during standard parameterization for one second, the
display switches to the extended parameterization mode. Operation is the same as in
standard parameterization.
To Next Page
Loading...
Need help?
General