Monuments Edge Series - Installation Guidelines; Safety Clearance Requirements

To Next Page

To Previous Page

Installation

The oor at the installation place must be leveled, (even) and capable of bearing corre-

sponding weight. Minor height differences can be compensated by the adjustable feet.

• The inner sauna cabin height must be at

least 210 cm.

• Observe at least 110 cm clearance between

the upper edge of the heater and the cabin

ceiling. (Fig. 1)

• The side (horizontal) gaps between the

heater and the cabin wall or the guard rail,

bench and other ammable materials are

stated in Fig. 2.

• The height of the protective heater guard

rail must approximately correspond to the

height in Fig. 3.

Safety gaps

Fig. 1

heater guard rail

12 cm

12 cm 12 cm

Fig. 2

guard rail

100 cm

ca. 85 cm

12 cm 12 cm

98 cm

min. 210 cm

35 cm

Fig. 3

ATTENTION! Do not operate the heater without feet!

ATTENTION! Install only on leveled surfaces! Risk of injuries

through tilting. Ensure vertical position of the heater.