Little Phatty CV Out Mod Directions
Introduction
Make your Little Phatty the center of a modular universe! This exciting modification gives you the power to control
Moogerfoogers and other analog gear with Control Voltages generated by your Little Phatty. LP CV Outs are for Pitch,
Gate, Volume Envelope, Filter Envelope and Mod Bus. All CVs are within +5 and -5 Volts.
Note: LP Tributes have a different wiring scheme and different right side piece assembly. Upgrading a Tribute will involve
more advanced drilling and applying an overlay to the wooden side piece. Please see the LP Tribute Addendum at the end
of this document for details.
Disclaimer: This mod should only be attempted by experienced technicians with a basic understanding of electronics, SOIC
soldering and the mechanics of drilling. The CV Out Mod is the most advanced Factory Mod that Moog offers at this time.
It takes time and skill to perform this mod successfully. You can easily damage an LP while attempting this mod. Please
read over all the instructions first and do not attempt this modification unless you feel confident doing so! Moog Music is
not responsible for any damages that may occur to your instrument while attempting this mod. Contact Moog Tech Support
for assistance (techsupport@moogmusic.com).
The Stage Kit Includes
Drilled Right Side Piece (gray plastic)
Overlay
Modified right Side Shield (metal)
CV Out PCB (BRD-10-011-614)
Crimped Wire Assembly #1 (red, yellow, green)
Crimped Wire Assembly #2 (orange, red, black, brown, yellow)
Three Adhesive Cable Holders (one extra)
5 Plastic Jack-nuts
5 Cable Ties
You Will Also Need
Solder + Soldering Iron
Wire Cutters
Phillips Screwdriver
Oscilloscope (for testing)
Isopropyl Alcohol
15 mm hex wrench
To Next Page
Loading...
