Page 20
LP User’s Manual - The Components
Page 21
LP User’s Manual - The Components
G – Input/Output Panel
The Side Panel provides all of the input and
output connects. In addition to the Audio Out-
put, there are CV and Gate inputs, connections
for MIDI, and the power connector and power
switch.
Power Connector:
This is a standard AC power inlet, Use only a power cord designed to mate with this receptacle. The Little
Phatty’s universal power supply is designed to work with power inputs of 90-250 Volts AC, 50/60 Hz.
IMPORTANT SAFETY NOTE – Do not alter the power connector in any way. Doing so can result in the
risk of shock, injury or death. Be familiar with the safety instructions printed at the beginning of this manual. If
the connector is damaged, refer servicing to qualied personnel only.
Audio IN:
The Audio In jack allows an external audio source to be mixed with the LP’s VCOs, and then routed to the
lter for processing. The LP has no provisions for adjusting the level of this input, it must be controlled exter-
nally. The audio input is designed to distort as the level of the external audio gets very high, adding color to
the sound.
Audio OUT:
The Audio Out jack provides an unbalanced line-level signal for connecting to an amplier or mixer.
MIDI Connectors:
These are connections for MIDI In and Out. There is no MIDI thru function.
CV Inputs:
The Pitch, Filter and Volume CV jacks supply power and will accept an expression pedal such as the Mooger-
fooger EP-1 (ring = +5.5 supply to the pedal, tip = variable CV return), or a control voltage from
–5 to +5 Volts. The KB Gate Input accepts a footswitch (a momentary, normally-closed footswitch like the
Moog FS-1) or a +5 Volt Gate Signal.
To Next Page
Loading...
