Moog Little Phatty - Interface Panel Controls

Page 22
LP User’s Manual - The Components
Page 23
LP User’s Manual - The User Interface
Preset mode is the default mode when the LP is powered on. Preset Mode is used to access presets and
provide control for editing, naming and storing sounds.
Preset sounds are selected using the VALUE knob. As the
VALUE knob is advanced, the next preset appears in the
display and is immediately available to be auditioned (you
do not need to ‘activate’ the preset to hear it). Pressing
VALUE and turning the knob will advance by increments
of ten.
You can use the front panel controls to edit the sound at
any point. Changing any of the front panel controls will
automatically switch the lower part of the display from
‘PRESET ACTIVE’ to ‘PANEL ACTIVE’, indicating that the
preset has been modied. The PRESET light also changes
its illumination from blue to purple, indicating that the
sound you hear is an edited version of the stored preset
You can toggle between the stored and edited sound by pressing the PRESET button. This acts like a
COMPARE function, allowing you to compare the sound of the original and edited presets. When using
the COMPARE function, the PRESET button will alternate colors and the LCD will display either ‘PRESET
ACTIVE’ (the original sound) or ‘PANEL ACTIVE’ (the edited sound).
NOTE: When switching between Master and Preset modes, the last used preset appears
in the display.
Preset Mode
Storing Presets
To store a preset, press the ENTER button. This button doubles as the STORE button in Preset mode as
indicated on the front panel. Store is used to save an edited preset (Panel Active), or to change the location
of a stored preset (Preset Active).
When you press STORE, the LCD will display the message shown.
Note there are actually two elds in this display. The rst eld is the
location where the preset will be saved, and the second is the YES/NO
eld, which gives you the chance to back out of the store operation
you change if your mind. Use the CURSOR key to toggle between
these elds. To save your preset, use the VALUE knob to select the
desired memory location where the preset will be saved.
If you change your mind or are unsure if you want to save your preset,
use the CURSOR button to toggle the YES/NO eld, then use the
VALUE knob to change from YES to NO. If NO is selected, pressing
STORE will simply return you to Preset mode without any action. You
can also press the PRESET button to escape without changes. If YES is
selected, pressing STORE will save the preset to the desired memory
location.