Moog Little Phatty - Page 24

Page 26
LP User’s Manual - The User Interface
Page 27
LP User’s Manual - The User Interface
EGR RELEASE/FILTER POLES:
This dual-function menu allows you to turn the EGR Release param-
eter ON and OFF, and select the number of lter poles. EGR Release
is used to enable/disable the Release segment of both the lter and
volume envelopes. The Filter Poles parameter is used to change the
lter response, from a gentle 6db/octave (1 pole) to a steep 24db/oct
(4 poles). To change the status of either parameter use the CURSOR
button to highlight the parameter, then use the VALUE knob to set the
new parameter value.
Values: EGR RELEASE: ON, OFF; the default is OFF
FILTER POLES: 1, 2, 3, 4; the default is 4
TRIGGER MODE:
Trigger mode allows you to select how the envelopes are triggered
when more than one key is pressed on the keyboard. A setting of
LEGATO ON means that the envelopes aren’t retriggered until the
key is fully released. A setting of EGR RESET will force the envelope
generators to start from 0 volts each time a note is triggered. To
change the trigger mode, use the CURSOR button to highlight the
parameter, then use the VALUE knob to set the new parameter value.
Values: LEGATO ON, LEGATO OFF, EGR RESET;
the default is LEGATO OFF
KEYBOARD PRIORITY:
Keyboard Priority allows you to select from 3 types of keyboard
priority. Keyboard priority for a monophonic instrument determines
what happens when more than one key is pressed. A setting of LOW
NOTE causes the lowest key pressed to sound, a setting of HIGH
NOTE causes the highest key pressed to sound, and a setting of LAST
NOTE causes the most recent key pressed to sound. To change the
keyboard priority, use the CURSOR button to highlight the parameter,
then use the VALUE knob to set the new parameter value.
Values: LOW NOTE, HIGH NOTE, LAST NOTE;
the default is LAST NOTE
VELOCITY SENSITIVITY:
VELOCITY SENSITIVITY allows you to select how the keyboard veloc-
ity will affect the lter cutoff (FILT) parameter. Positive values increase
the velocity sensitivity, raising the lter cutoff parameters as the keys
are struck harder, mimicking the properties of acoustic instruments.
Negative values will have the opposite effect, lowering the lter cutoff
parameters as the keys are struck harder. To change the value use
the CURSOR button to highlight the parameter, then use the VALUE
knob to set the new parameter value.
Values: +/-8; the default is 0