Moog Minitaur

SETUP:
Click the SETTINGS button to open the Settings window:
When connecting your Minitaur and computer via USB, set the MIDI Input and MIDI Output in the
EDITOR SETTINGS section to “Moog Minitaur”.
Once theses MIDI Input and Output settings are selected, the MINITAUR GLOBAL SETTINGS displayed in the
editor will update to reflect the current status of the connected Minitaur’s internal global settings.
Note: Changes made to the editor’s global settings are saved to the connected Minitaur’s internal memory.
This page also provides access to the MINITAUR CV MAPPING settings, and the MINITAUR CV
CALIBRATION UTILITY.
See pages 17 (Editor Manual) for detailed information on the SETTINGS window.
Your Minitaur’s current firmware version is displayed in the lower right corner of the Preferences window.
3