12
MOTHER-32 FIRMWARE UPDATE V2.0 April 2020
SETUP MODE GLOBAL DEFAULTS
BUG LIST
BUGS FIXED IN VERSION 2.0
1. The Clock Output (Assignable Output Modes 2, 3, 4) is no longer aected by Ratcheting steps.
2. MIDI note-o commands received while sequencer is playing no longer truncate the currently-
playing note.
3. Invalid glide times present after changing patterns have been fixed.
4. MIDI notes will now transpose the sequence even when sequence is not playing. (i.e. before the
sequencer is started.)
5. Phase alignment is maintained between the Mother-32 sequencer and the analog clock output.
KNOWN ISSUES IN VERSION 2.0
1. If starting/resuming playback while synchronized to an external clock, you must start playback on a swing
onbeat in order to stay correctly aligned to the external clock.
Example: If using MIDI Song Position Pointer to begin playback later than the beginning of a pattern, you should
start playback on a swing onbeat. Otherwise, pattern playback may begin with a slight delay.
PAGE 1: ASSIGNABLE Output Jack Sequencer Clock Output
PAGE 2: MIDI Channel Selection Channel 1
PAGE 3: TEMPO Input jack Step Advance / Trigger
PAGE 4: Clock Input PPQN 4 (sixteenth note)
PAGE 5: Clock Output PPQN 4 (sixteenth note)
PAGE 8: Follow MIDI Clock On
PAGE 8: Follow MIDI Start / Stop On
PAGE 8: Clock Output Swing On
PAGE 8: Tempo Input Range O (-5V to +5V)
PAGE 8: Accent Out CV Only O
PAGE 8: Load Saved Timing On
To Previous Page
Loading...
