11
PAGE 5: CLOCK OUTPUT PPQN (Pulse Per Quarter Note)
Here you can set the number of outgoing clock pulses that will equal one quarter note.
NOTE: 24 PPQN is used by the DIN SYNC standard; 48 PPQN is used by some older drum machines
PAGE 6: SAVE MODE
This page allows you to specify the Save mode for your Mother-32. The full descriptions of each mode can
be found under the SAVING A PATTERN section of this manual.
PAGE 7: [RESERVED]
There are no user accessible parameters on this Page.
PAGE 8: ON / OFF PARAMETERS
The parameters available on this page can be toggled On or O so that your Mother-32 will behave in a way
conductive to your creative process.
1: 1 PPQN
2: 2 PPQN
3: 3 PPQN
4: 4 PPQN
5: 5 PPQN
6: 6 PPQN
7: 7 PPQN
8: 8 PPQN
9: 9 PPQN
10: 10 PPQN
11: 11 PPQN
12: 12 PPQN
13: 13 PPQN
14: 14 PPQN
15: 24 PPQN
16: 48 PPQN
1: Manual Save mode
2: Auto Save mode (added in Version 2.0)
3: Write Protect mode (added in Version 2.0)
1: Follow MIDI Clock (On / O)
2: Follow MIDI Start Stop (On / O)
3: Clock Output Swing (On / O)
4: Accent Out CV Only
ON: The internal Accent circuit is disabled when the ASSIGN Output Jack is set to Accent (Page 1;
Parameter 1).
OFF: The internal Accent circuit is enabled.
5: Tempo Input Range
ON: The voltage range of the TEMPO input is 0V to +5V
OFF: The voltage range of the TEMPO input is -5V to +5V
6: Delay Pattern Change
ON: When a new Pattern is selected, the sequencer will finish playing the current pattern before
switching to the new pattern
OFF: When a new Pattern is selected, the sequencer will begin to play the new pattern
immediately.
7: Load Saved Timing
ON: When a new Pattern is selected, the timing settings (Clock Division, Swing Interval, and
Swing Amount) that were saved with the pattern will be restored.
OFF: When a new Pattern is selected, the previously-active timing settings will remain unchanged.
MOTHER-32 FIRMWARE UPDATE V2.0 April 2020
To Next Page
Loading...
