26
OSCILLATORS (Continued)
VCO MODE (SAWTOOTH, TRIANGLE)
This parameter shows the status of the WAVE button on the front panel. This function can also be
controlled here.
PITCH TRACKING (0 to 200%)
With this parameter set to 100%, the pitch of the Oscillator will track the keyboard as normal. In some
cases you may want to change this value. For example, at 0%, the Oscillator would play the same pitch,
regardless of the note played. Another example would be to set an Oscillator to Hard Sync, and utilize
an excessive value (150% - 200%) to enhance the effect.
NOTE-ON RESET (OFF, ON)
Normally, an Oscillator is constantly running, and each new note played begins from the current point
in the waveform cycle. When NOTE-ON RESET is On, the phase of the Oscillator is reset to zero with
each new note-on command, which can make for extremely punchy bass sounds.
BEND OFFSET
The Bend Offset amount is set individually for each oscillator, and is combined with the per-Synth
Pitch Bend Up and Down values set on the LHC MORE Page. Bend Offset provides separate values for
Bend Up and Bend Down, and each can be set to either a positive or a negative value. In this way, the
Pitch Bend wheel can be used to resolve each oscillator to a specic note or interval at either end of its
travel, allowing for creative harmonies and chords to be introduced as part of a performance.
BEND UP OFFSET (-24 to 0 to +24)
This parameter species the amount of Pitch Bend Offset applied to the Oscillator when the
Pitch Bend wheel is moved Up. When the value is set to zero no offset is added. Negative
offset values will bend the pitch down; positive values will bend the pitch up. The range is +/-
24 semitones (two octaves).
BEND DOWN OFFSET (-24 to 0 to +24)
This parameter species the amount of Pitch Bend Offset applied to the Oscillator when the
Pitch Bend wheel is moved Down. When the value is set to zero no offset is added. Negative
offset values will bend the pitch down; positive values will bend the pitch up. The range is +/-
24 semitones (two octaves).
HARD SYNC SRC. (Oscillator 2 and Oscillator 3 only)
The default source for Hard Sync on Oscillator 2 and Oscillator 3 is Oscillator 1. Here, a different
oscillator can be designated as the Hard Sync source.
OSCILLATOR 2 (VCO 1, VCO 3)
OSCILLATOR 3 (VCO 1, VCO 2)
To Next Page
Loading...
Need help?
General
