moon Eclipse - Operating the CD Player; First Time Power On Sequence; On and Off Sequence; Recommended Power State

MOON Eclipse CD Player
Operating the Eclipse
Turning on your MOON Eclipse for the first time
Prior to turning this CD Player on for the first time, make sure that every cable is properly connected to
avoid any problems. Then turn on your CD Player in the following manner:
1) Flick the main rocker switch labeled “POWER” to the ‘1’ (on) position on the rear of the power supply.
The blue LED on the front of the power supply will indicate that the power supply is on.
2) The blue LED on the front of the Eclipse indicates that it is correctly connected to the power supply.
Press the push button labeled “Stand by” on the Eclipse, and the digital display will show ‘no disc’.
You are now ready to load a compact disc and begin listening to music.
On and Off Sequence
To avoid having any annoying noises (ie. “thumps” and “pops”) emanate from your speakers when
powering your Eclipse on or off, you should
1) Always power up your Eclipse CD Player before powering up your preamplifier and/or amplifier.
2) Always power down your Eclipse after powering down your preamplifier and/or amplifier.
We recommend that you leave your MOON Eclipse CD Player powered up at all times to maintain
optimal performance. In the event that you plan to be away from your home for a few days, powering
off the CD Player may not be a bad idea. Once fully “broken-in”, please keep in mind that your Eclipse
will require several hours of playing time before it reaches its peak performance after you’ve powered it
up again.
____________________________________________________________________________________
Operating The Eclipse 14