29
02/02
SAFETY MAINTENANCE SCHEDULE
NOTE: During the first hours of operation, check bolt and belt tightness frequently. After the first
week, check tightness of belts and bolts weekly. Please refer to torque schedule.
GENERAL DAILY WEEKLY
Check engine oil level X
Check radiator fluid level X
Check battery water level (fill with distilled water) X
Check hydraulic fluid X
Check clutch engagement torque X
Check tightness of engine bolts* X
Check tire pressure before moving machine
Replace engine air, fuel and oil filters refer to engine manual
CHIPPER
Check sharpness of knives X
Check tightness of chipper bearing bolts* X
Check tightness of chipper knife bolts* X
Check for proper anvil clearance every time you check chipper knives
Check for worn anvil edge X
Check for proper drive belt tension* X
Check tightness of chipper sheave bushing* X
Torque chipper drive sheave* X
* Refer to torque specs. (see pg. 36)
To Next Page
Loading...