Pre Start Inspection and Operation
3.7
Before starting the engine:
• Move all hydraulic control levers forward and release the lever. Make sure that
each lever automatically returns to the Neutral position.
• Move all hydraulic control levers rearward and release the lever. Make sure that
each lever automatically returns to the Neutral position.
• The Auxiliary Control Lever will remain in last position used until it is manually
moved to the Neutral position.
• If any of the levers, other than the Auxiliary Control Lever, do not automatically
return to the Neutral position, DO NOT use the machine until repairs have been
made.
Figure 3-7 Lubrication Points
To Next Page
Loading...
