• Watch the area around the moving parts to avoid collision against the body parts or other objects
which may result in injury.
• The EQUIPMENT should not be used adjacent to or stacked with other equipment and that if adjacent
or stacked use is necessary, the EQUIPMENT should be observed to verify normal operation in the
configuration in which it will be used.
• Do not fail to turn the unit off after use; this will eliminate the risk of electrical leakage and accidents.
• The main switch should be turned off during standard maintenance procedures. It is also
recommended that the main breaker or fuse on the main electrical distribution panel be turned off as
some electricity reaches the main power terminal inside the unit even when the main switch is off.
• Do not use this equipment for patients when it is being maintained or serviced.
• Use special care to explain to the patient proper instructions as to when they can move as there are
“multiple movements” with certain exposures.
• Do not press the panel too hard not to damage the panel.
• Make sufficient space around the Main Switch so that it is easily accessible in case of emergency.
• Make sufficient space around the power plug so that it is easily unplugged in case of emergency.
(For EX-1)
• Make sufficient space around the power distribution panel so that it is easily to open the breaker in
case of emergency. (For EX-2)
• To avoid the risk of electric shock, this equipment must only be connected to the supply mains with
protective earth.
• Do not use multiple portable socket outlet nor extension cord for the system power supply.
• Do not touch simultaneously the patient and the conductive parts, such as the connector terminals.
To Next Page
Loading...
Need help?
General
