SECTION 4
34
Direct Connection (RS-232)
For a direct connection, set the SYNC media to RS-232. Connect the ELI 350 to another Mortara Instrument
electrocardiograph, to an E-Scribe, or to ELI Link with a direct connect serial cable.
In the configuration setting, select matching baud rates for both units. Use 38400 bps for a direct connection
to E-Scribe.
Modem Transmission
For a modem transmission, set the SYNC media to modem. Connect the ELI 350 to a standard telephone jack with
the provided phone line cable. Plug the cable into the telephone jack located on the back of the electrocardiograph
and the other end into a telephone wall jack. Confirm telephone number in the configuration settings.
Modem Initialization
The modem initialization string is country specific. At the time of production, the modem initialization string is
configured for the country of purchase; however, if the unit is relocated to a different country, the modem
initialization string will need to be modified. Contact Mortara Instrument Customer Service to receive the procedure
to change the code.
External Modem
Before using the external modem, modem command(s) must be entered and two configuration settings must be
defined. Set the SYNC media to external modem, and set the baud rate to 57600.
From the Configure Modem screen, enter and send the initialization command as AT&FEQX4&K.
If a country specific code is necessary, the following list of countries require “%T19,0,XX” to be added to the
modem initialization string. Where “XX” is replaced by the country code number in the following table.
To Next Page
