Motorline MC2 - 01. SAFETY INSTRUCTIONS; SAFETY STANDARDS AND CERTIFICATIONS; USER & INSTALLER RESPONSIBILITIES

1A 1B
PTPT
INDEX
STANDARDS TO FOLLOW
00. CONTENT 01. SAFETY INSTRUCTIONS
1B
11
11
12
2A
3A
9B
10A
4A
10A
10B
6B
8A
ATTENTION:
• To ensure the safety of people, it is important that you read all the following instruc-
tions.
• Incorrect installation or incorrect use of the product can cause physical injury and
material damage.
• This product was designed and produced strictly for the use indicated in this manual.
Any other use, not expressly indicated here, could compromise the good condition/ope-
ration of the product and/or be a source of danger, and will void the warranty.
• ELECTROCELOS S.A. is not responsible for the improper use of the product, or other
use than that for which it was designed.
• ELECTROCELOS S.A. is not responsible if safety standards were not taken into ac-
count when installing the equipment, or for any deformation that may occur to it.
• ELECTROCELOS S.A. is not responsible for the safety and proper operation when
using components not sold by them.
• Do not make any modifications to the operator components and / or their accessories.
• Before installation unplug the automatism from the source of power.
• The installer must inform the client how to handle the product in case of emergency
and provide this manual to user.
• Keep remote controls away from children, to prevent the automated
system from being activated involuntarily.
• The customer shall not, under any circumstances, attempt to repair or tune the auto-
matism. Must call qualifid technician only.
• Connect the automatism to a 230V plug with ground wire.
• Control board for indoor use.
STANDARDS TO FOLLOW
TECHNICAL SPECIFICATIONS
PROGRAMMING PRE-RECOMENDATIONS
MAIN MENU
EXTENDED MENU 3
PHOTOCELLS TESTING AND REMOTE CONTROLS
INSTRUCTIONS FOR FINAL CONSUMERS
EXTENDED MENU 1
RESET OF CONTROL BOARD
CAPACITATOR SCHEME
INSTRUCTIONS FOR SPECIALIZED INSTALLERS
EXTENDED MENU 2
01. SAFETY INSTRUCTIONS
02. THE CONTROL BOARD
03. CONFIGURATION
04. COMPONENT TEST
05. TROUBLESHOOTING
CONTROL BOARD CONNECTION COMPONENT
06. CONNECTION SCHEME