Motorline MC52 - Page 13

12A 12B
ENEN
RESET - RESET FACTORY VALUES
RGB OUTPUT
MANUEVERS COUNTER
. PROGRAMMING "E"
. PROGRAMMING "E"
. PROGRAMMING "E". PROGRAMMING "E"
. PROGRAMMING "E"
. PROGRAMMING "E"
1º  
2º 
display flashes display flashes
04 • The maneuvers count is displayed in the following order (example: 130 371):
05 • E8 appears.
3º dozens
2º thousands1º hundred thousand
01 • Press MENU for 10 sec. until it appears .
02 • Use UP until appears .
03 • Press Menu will appear .
04 • Press MENU to edit the value.
05 • Use UP and DW to change the value.
06 • Press MENU to save the new value.
01 • Press MENU for 10 sec. until it appears .
02 • Use UP until appears .
03 • Press Menu will appear .
04 • Press MENU to edit the value.
05 • Use UP and DW to change the value.
06 • Press MENU to save the new value.
This menu allows you to reset to factory defaults.
The default value is 0 (deactivated).
This menu allows you to set the operation mode of RGB outputs.
The default value is 0 (continuous output).
BRAKE/LOCK/PUSH
01 • Press MENU for 10 sec. until it appears .
02 • Use UP until appears .
03 • Press Menu will appear . Use UP or DW to navigate the parameters.
04 • Press MENU to edit the chosen parameter value.
05 • The factory set time appears. Use UP and DW to change the value.
06 • Press MENU to save the new value.
01 • Press MENU for 10 sec. until it appears .
02 • Use UP until appears .
03 • Press Menu the value set by the factory will appear.
04 • Press MENU to edit the value.
05 • Use UP and DW to change the value.
06 • Press MENU to save the new value.
This menu allows you to adjust the deceleration speed.
The higher the slowdown level, the faster the slowdown.
The default value is 4.
DECELERATION SPEED
MANUEVERS COUNTER
This menu allows you to view the number of maneuvers performed.
(complete maneuver means opening and closing).
Resetting the control board does not clear the maneuver count.
Example: 13456 maneuvers
01- Hundred thousand / 34- Thousands / 56- Dozens
01 • Press MENU for
10 secondes.
02 • E0 appears.
Press UP until
appears E7.
03 • Press MENU.