To configure and enable a Guest Network on the 2.4 GHz band, first select the 2.4
GHz tab, and then:
1 Select the desired Guest Network (there are seven available).
2 Click the Save button.
3 Select Enabled and click Save to enable the selected Guest Network.
The following steps are optional. Follow them if you want to change the default
Guest Network Name and Password:
4 Select and delete the old Guest Network Name, then type in the new
Guest Network Name and click Save.
5 You can click the Show Key box to check your typing for Password.
6 Select and delete the old Password, then type in the new Password.
7 Click the Save button.
To configure and enable a Guest Network on the 5 GHz band, first select the 5
GHz tab, and then repeat the steps above.
Network Name can be from 6 - 32 characters long. You can use the upper and lower
To Next Page
Loading...
