Motorola APX 3000

xiv List of Figures
Figure 8-5. Removing the Battery ........................................................................................................... 8-6
Figure 8-6. Disengage the Chassis ......................................................................................................... 8-7
Figure 8-7. Remove the Chassis Assembly ............................................................................................8-7
Figure 8-8. Remove the chassis screws.................................................................................................. 8-8
Figure 8-9. Remove the Secondary Shield Assembly............................................................................. 8-8
Figure 8-10. Remove the Main O-Ring at the antenna holder................................................................... 8-9
Figure 8-11. Lift up the Main Board from the Chassis ............................................................................... 8-9
Figure 8-12. Remove Battery Seal .......................................................................................................... 8-10
Figure 8-13. Serviceable Components – Main Board Assembly ............................................................. 8-10
Figure 8-14. Serviceable Components – Chassis Assembly................................................................... 8-11
Figure 8-15. Serviceable Components – Main Housing .......................................................................... 8-14
Figure 8-16. Assemble the Battery Seal.................................................................................................. 8-15
Figure 8-17. Assemble the Main O-Ring at Antenna Holder ................................................................... 8-15
Figure 8-18. Assemble the RF Board ...................................................................................................... 8-16
Figure 8-19. Assemble the Secondary Shield Assembly......................................................................... 8-16
Figure 8-20. Torque in the Chassis Screws............................................................................................. 8-17
Figure 8-21. Slide chassis assembly into Front Housing......................................................................... 8-17
Figure 8-22. Assemble Back Kit and Front Kit together .......................................................................... 8-18
Figure 8-23. Engaging Hook and Seating Cover.....................................................................................8-18
Figure 8-24. Securing the Cover ............................................................................................................. 8-19
Figure 8-25. Attaching the Antenna......................................................................................................... 8-19
Figure 8-26. Assemble the Seal, Vacuum Port........................................................................................ 8-20
Figure 8-27. Assemble the Label Gore Port ............................................................................................ 8-20
Figure 8-28. Assemble the Bottom Label ................................................................................................ 8-21
Figure 8-29. Attaching Battery – Slide into Position ................................................................................ 8-21
Figure 8-30. Attaching Vacuum Test Fixture............................................................................................ 8-24
Figure 10-1. APX 3000 Front Kit Exploded View ....................................................................................10-2
Figure 10-2. APX 3000 Back Kit Exploded View.....................................................................................10-4