Motorola APX 4000 - Display Radio Test Mode

Performance Checks: Display Radio Test Mode 5-3
5.2 Display Radio Test Mode
This section provides instructions for performing tests in display radio test mode.
5.2.1 Access the Test Mode
To enter the display radio test mode:
1. Turn the radio on.
2. Within 10 seconds, press Side Button 2 five times in succession.
The radio shows a series of displays that give information regarding various version numbers
and subscriber specific information. The displays are described in Table 5-2.
Table 5-2. Test-Mode Displays
Name of Display Description Appears
Service The literal string indicates the radio has
entered test mode.
Always
Host version The version of host firmware is displayed. Always
DSP version The version of DSP firmware is displayed. Always
Model number The radio’s model number, as
programmed in the codeplug
Always
Serial number The radio’s serial number, as programmed
in the codeplug
Always
ESN The radio’s unique electronic serial
number
Always
ROM Size The memory capacity of the host FLASH
part
Always
FLASHcode The FLASH codes as programmed in the
codeplug
Always
RF band 1 The radio’s operating frequency Always
Tuning Ver Version of Tuning codeplug Always
Proc Ver Version of Processor Always
Option Board
Type
Type of Keypad board being used When the radio has an Option
Board/Expanded Keypad Board.
Option Board
Serial Number
Serial number of the Keypad board is
displayed
When the radio has an
Expanded Keypad Board.
Option Board
Sw Version
Software version of the Keypad Board is
displayed
When the radio has an
Expanded Keypad Board.
Exp Board Type Type of Keypad Board is displayed When the radio has a Keypad
Board.