Logging in via the Two-Factor Authentication
1 Perform one of the following actions:
• Press the preprogrammed User Login button.
•
or to User, and press the Menu Select
button directly below User.
The display shows the User Login screen.
2 Perform one of the following actions:
•
or to [ID Entry] and press the Menu
Select button directly below Edit. A blinking
cursor appears. Use the keypad to type or edit
a username. Press the Menu Select button
directly below Ok to submit.
•
or to scroll through the list of predefined
usernames. Press the Menu Select button
directly below Sel to select the predefined
username.
• Press and hold
or to scroll through the
list of predefined usernames at a fast scroll
rate. Press the Menu Select button directly
below Sel to select the predefined username.
If the selected predefined username has more
than the maximum allowed characters, or an
invalid character in it, the display shows
momentary Invalid ID.
3 For radio enabled with Unit ID, Perform one of the
following actions:
•
or to [UnitID Entry] and press the
Menu Select button directly below Edit. A
blinking cursor appears. Use the keypad to
type or edit a Unit ID. Press the Menu Select
button directly below Ok to submit.
• or to scroll through the list of predefined
Unit IDs. Press the Menu Select button directly
below Sel to select the predefined Unit ID.
• Press and hold or to scroll through the
list of predefined Unit IDs at a fast scroll rate.
Press the Menu Select button directly below
Sel to select the predefined Unit ID.
If the selected predefined Unit ID has more than
the maximum allowed characters, or an invalid
character in it, the display shows momentary
Invalid UnitID.
4 Enter your password when you see a blinking
cursor.
114
English
To Next Page
Loading...
Need help?
General
