Motorola APX 900 - Location Feature in Emergency Mode; Mission Critical Geofence (ASTRO 25 Trunking); Entering the Geofence Area

2 or to Dist frm here and press the Menu Select button directly below Sel .
The display shows a list of waypoints.
3 or to the required waypoint and press the Menu Select button directly below Sel .
The display shows the distance and bearing from the current to the selected coordinates.
7.19.13
Location Feature in Emergency Mode
When the Emergency feature is activated, the radio exits the Location menu and returns to the Home
screen.
You can view the channel that triggers the emergency signal.
You can reenter the Location menu while still in Emergency mode as long as Silent Emergency is not
activated.
If you have disabled the Location feature on your radio, it automatically turns back on when Emergency
mode is activated.
If there is a solid location signal during Emergency operation, the current location and the location
information received is saved as Emergency and Last Known Location respectively.
7.20
Mission Critical Geofence (ASTRO 25 Trunking)
This feature allows your radio to use the Global Positioning System (GPS) receiver to determine
its location at frequent intervals, and evaluate if the radio is within the Geofence area in real time.
Geofence is a virtual perimeter based on the GPS to define a geographical area on earth.
When your radio enters the predefined Geofence area, your radio receives the Dynamic Regroup
command from the system, and immediately connects to a Dynamic Regroup talkgroup. The radio
display shows the new selected Dynamic Regrouped talkgroup with green intelligent light for your
attention. Voice Announcement is also available to support this feature.
Any new text messages received at Geofence are displayed immediately on the radio display.
NOTE:
If the radio is set up in DVRS, only mobile radio is supported for this feature.
7.20.1
Entering the Geofence Area
Prerequisites: The Voice Announcement and TMS display in this feature are optional. They must be
configured to enable you to hear and see these indicators.
When and where to use: When the radio enters a Geofence area, the radio immediately sends a
message ACK back to the system.
The radio searches the current zone for the channel with same talkgroup assigned as the Dynamic
Talkgroup and also with same system ID of current trunk system. Once matched, the radio display
shows the first matched and connected channel alias.
If there is no channel with matching Talkgroup ID and trunk system ID, the radio display shows the
channel alias of <DYNAMIC talkgroup>.
MN003441A01-AP
Chapter 7 : Advanced Features
100