Motorola APX 900 - Page 126

Parameter Editing Keys Value
Power Level High/Low
Hot Keypad ON/OFF
Busy LED ON/OFF
Low Batt
LED
ON/OFF
MPL Enable Disabled/Rx
/Tx/All
Scan List None/Scan
List 1, 2,
3,...
Zone Name Use keypad to enter numbers and alphabet characters. For more informa-
tion, see Text Entry Icons on page 21.
Top Chan
Name
Top Zone
Name
Chan Name
NOTE:
To edit Tx PL, Rx PL, Tx DPL, and Rx DPL, the PL Setting must be set to Disabled.
If PL setting is set to ALL, Rx or Tx, there is no Edit selection available to change the
codes for Tx PL, Rx PL, Tx DPL, or Rx DPL.
If PL setting is set to Rx, you can only edit Tx PL and Tx DPL codes.
If PL setting is set to Tx, you can only edit Rx PL and Rx DPL codes.
MN003441A01-AP
Chapter 7 : Advanced Features
126