Motorola ASTRO XTS 5000 III - Conventional Scan Only

ASTRO XTS 5000 Model III 55
Common Radio Features
Conventional Scan Only
Make a Dynamic Priority Change
While the radio is scanning, the dynamic priority change feature lets
you temporarily change any channel in a scan list (except the Priority
1 channel) to the Priority 2 channel. The replaced Priority 2 channel
becomes a non-priority channel. This change remains in effect until
scan is turned off, then scanning reverts back to the preprogrammed
state.
1 When the radio is locked
onto the channel to be
designated as Priority 2,
press the preprogrammed
Dynamic Priority button.
Note: The Priority 1 channel
cannot be changed to
Priority 2.
2 The radio continues scanning
the remaining channels in the
list. To resume scanning the
preprogrammed Priority 2
channel, you must leave and
re-enter scan operation.
94C27-K_XTS5000_MIII.book Page 55 Tuesday, May 6, 2008 4:33 PM