21
Phonebook
4. Phonebook
You can store up to 50 names and numbers in the phonebook. Names can be
up to 12 characters long and numbers up to 24 digits.
4.1 Store a name and number
If the C1CB+ is connected to a switchboard, you may need to enter a pause in a
stored number. This gives the switchboard time to find an outside line.
A pause is normally stored after the switchboard access code (e.g. 9). When
storing a number, press and hold
until the display shows P. You can then
continue entering the phone number.
If you have subscribed to Caller ID Service and wish to display the name of
your caller instead of the number, save the full telephone number including the
area code to your phonebook.
You can store multiple entries with the same name. However, to prevent
unnecessary duplicated entries, you can only store the number once.
1. Press . The display shows
PHONEBOOK
.
2. Press , scroll
d
to
ADD NEW
.
3. Press . The display shows
ENTER NAME
.
4. Enter the name and press . The display shows
ENTER NUMBER
.
5. Enter the number and press to save. The display shows
ADD NEW
.
6. Enter the next name and number entry that you wish to store in your
phonebook or press e to return to standby mode.
Entering names
Use the keypad letters to enter names, e.g. to store TOM:
Press once to enter T.
Press three times to enter O.
Press once to enter M.
Writing tips
Press
B
to delete the last character or digit.
Press u or
d
to move between characters or digits.
Press to insert a space.
Press twice to insert a dash.
To Next Page
Loading...
