41
Services
7. Press n to return to standby.
Note
If no detect number is set the prefix number will be added to all pre-dialled
numbers.
11.4 Recall time
This setting is useful to access certain network and PABX / switchboard services.
The default C42 recall time is suitable for your country and network operator. It is
unlikely that you should need to change this setting unless advised to do so.
1. Press
m, scroll d to
Services
and press m.
2. Scroll
d to
Recall time
and press m.
3. Scroll
u or d to
Short
,
Medium
or
Long
and press m to confirm.
4. Press
n to return to standby.
11.5 Dial mode
Your C42 is set to tone dialling. You should only need to change this if connected
to an older type of switchboard / PABX which requires pulse dialling.
1. Press
m, scroll d to
Services
and press m.
2. Scroll
d to
Dial mode
and press m.
3. Scroll
u or d to
Tone
or
Pulse
and press m to confirm.
4. Press
n to return to standby.
11.6 Auto clock
If you have subscribed to Caller ID Service, the date and time will be set on all
your handsets whenever a call is received. This feature can be set to On or O.
1. Press
m, scroll d to
Services
and press m.
2. Scroll
d to
Auto clock
and press m.
3. Scroll to
On
or
O
and press m to confirm.
11.7 Register a handset
You can register up to 4 handsets to your C42 base to extend your phone system
without having to install extension sockets for each new phone.
If you have purchased a C42 multiple pack, all additional handsets come pre-
registered to the base.
If you have purchased an additional handset separately, you must register it to
your C42 base before it can be used.
Note
Handset batteries must be fully charged before you start to register. Hold your
handset close to the base during the registration process. Handsets that were
supplied with your C42 base are already pre-registered.
To Next Page
Loading...
Need help?
General
