Radio Disassembly — Detailed 4-7
8. Unplug the wires from the 4-pin connector.
6.2 Chassis Assembly Disassembly
Use a TORX™ screwdriver with a T6 head to remove the four screws holding the main board to the
chassis.
1. Lift the main board from the chassis (See Figure 4-5).
Figure 4-4 Unlatch Flex Connectors
Figure 4-5 Remove Main Board from Chassis
CAUTION: Refer to the CMOS CAUTION paragraph on page 2 before removing the main board. Be sure
to use ESD protection when handling circuit boards.
Latch
Jumper Flex
4-Pin Connector
Wire Assembly
Main Board
Radio Chassis
O-Ring
Retaining Features
Po
To Next Page
Loading...
